Dragma

Scissor Lift help

Recommended Posts

I know how to make a scissor lift (criss cross technic beams or bricks using pins or axles)  my question is how to do one using just the thin liftarms so it fits in a 1 stud wide space. I have not found any connectors (axles or pins) that will work

Share this post


Link to post
Share on other sites

You might not like it, but it will work. Take one of these 24316, cut it to a length of about 5 millimeter ( just a little larger then two thin liftarms on top of each other), place it, and then take a hot knife or something and melt the cutted side to form a little rim, that will keep the part in place.

Take care,
Simon

 

Edited by Simon
typo

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now