Snot Headlight Brick In Practice

Recommended Posts

I discovered an issue with the headlight brick and for a long time I tought I was the only one had it, until I found this photo from Sheo:

Officially the depth of the offset of the front is half a plate (4 LDU) and it should be possible to put a brick with stud on side on it and the the top stud of the headlight-brick and the side stud of the other brick should be in system. However, the distance is slightly longer and when attaching something to those bricks stress occurs. I have never found this in official LEGO-builds either. This issue also appears when using a headlight-brick with a plate when it should match with a SNOT-bracket but does not.

Are there more people who discovered this?

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.